Inleiding

The motherboard controls the operations of the camera. Damage to the motherboard requires an entirely new motherboard.

Onderdelen

Geen onderdelen nodig.

  1. Slide grey latch to open the battery compartment.
    • Slide grey latch to open the battery compartment.

    Voeg opmerking toe

  2. Push orange retaining clip to the right to free battery.
    • Push orange retaining clip to the right to free battery.

    Voeg opmerking toe

    • Remove battery from the camera.

    Voeg opmerking toe

    • Remove the lanyard.

    Voeg opmerking toe

    • Remove the two 2.3mm screws (underneath the name plate) and two 2.8mm screws (next to the threaded tripod mount) from the bottom face of the camera.

    • Be careful to keep track of the different screw sizes as you proceed with this guide.

    Voeg opmerking toe

    • Remove the single 3.8mm screw from the back face of the camera.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Remove the two 2.3mm screws from the right face of the camera.

    Voeg opmerking toe

    • Remove the two 3.2mm screws (outside edge) and two 3.7mm screws (towards middle) from the left side of the camera body.

    Voeg opmerking toe

    • Pull the back face panel away from the front end of the body. This may take some wiggling and force.

    Voeg opmerking toe

    • Remove the CF card door from the left side of the camera body.

    Voeg opmerking toe

    • Remove the rubber digital a/v out cap by sliding it out of the groove on the front plate.

    Voeg opmerking toe

    • Remove the front face by sliding it off.

    Voeg opmerking toe

    • Remove the rubber seal that goes over the right side of the viewfinder.

    Voeg opmerking toe

    • Remove the two 3.9mm screws that retain the laminated cooper sheet.

    Voeg opmerking toe

    • Remove the seven wire connections that connect to the motherboard.

    Voeg opmerking toe

    • Remove the single 3.8mm screw that is on the motherboard.

    Voeg opmerking toe

    • Carefully remove the motherboard from the main frame of the camera body.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Orlando Zuniga

Lid sinds: 14-04-11

11 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team 20-70, Walters Spring 2011 Lid van Cal Poly, Team 20-70, Walters Spring 2011

CPSU-WALTERS-S11S20G70

5 Leden

4 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 1,623