Ga door naar hoofdinhoud

Inleiding

This guide is for accessing the cameras internal components for repairs and troubleshooting.

Onderdelen

Geen onderdelen opgegeven.

  1. To avoid severe electric shock do not remove or tamper with internal camera flash components. An electrical capacitor is attached to the flash that can discharge if contact is made. Remove the two side screws, indicated by the red circles, using a Phillips #00 screwdriver. Remove the screw in the battery port, indicated by the blue circle, again using a Phillips #00 screwdriver.
    • To avoid severe electric shock do not remove or tamper with internal camera flash components. An electrical capacitor is attached to the flash that can discharge if contact is made.

    • Remove the two side screws, indicated by the red circles, using a Phillips #00 screwdriver.

    • Remove the screw in the battery port, indicated by the blue circle, again using a Phillips #00 screwdriver.

    • Remove the front face by gently peeling the housing away from the camera.

  2. Remove the back face by using a spudger to lift the tab highlighted in yellow Pivot the back face clockwise as seen in the second photo. Pivot the back face clockwise as seen in the second photo.
    • Remove the back face by using a spudger to lift the tab highlighted in yellow

    • Pivot the back face clockwise as seen in the second photo.

  3. Remove the A/V port cover [no tools are necessary] Remove the A/V port cover [no tools are necessary]
    • Remove the A/V port cover [no tools are necessary]

Conclusie

To reassemble your device, follow these instructions in reverse order.

iDeleted

Lid sinds: 07-07-10

2.101 Reputatie

39 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 837