Inleiding

Remove the back cover before removing LCD.

Onderdelen

Geen onderdelen nodig.

Remove one 2.25mm screw on the bottom.
  • Remove one 2.25mm screw on the bottom.

Voeg opmerking toe

Remove two 2.25mm screws on the right side looking from the front.
  • Remove two 2.25mm screws on the right side looking from the front.

Voeg opmerking toe

  • Remove one 4.7mm screw on the side with the AV output.

Voeg opmerking toe

  • Pull off the back cover.

  • The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

Voeg opmerking toe

  • Remove 2 2.4mm screws on bottom.

Voeg opmerking toe

  • Follow the small data cable to where it connects to the camera.

  • Lift the back white portion to unlock the cable.

  • The cable should easily slide out.

  • The connector is very fragile. Use caution when lifting the lock.

Voeg opmerking toe

  • Gently lift LCD display off.

  • There will be two data cables still attached to the camera. Do not break them.

  • There may be a loose strip of metal along the inner side of the LCD display for a secure fit.

Voeg opmerking toe

  • Follow the larger cable to where it connects to the camera.

  • Lift the front black portion of the connector to unlock the data cable.

  • The cable should easily slide out.

  • The connector is very fragile. Use caution when lifting the lock.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Jeremy Rabaino

Lid sinds: 10-10-10

135 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 20-9, Maness Fall 2010 Lid van Cal Poly, Team 20-9, Maness Fall 2010

CPSU-MANESS-F10S20G9

5 Leden

6 handleidingen geschreven

Één commentaar

where can I buy a replacement LCD screen for a SD800 IS

ALFRED - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 2,090