Inleiding

This guide should be used if our guide, "Cleaning Function Buttons", doesn't fix your function buttons.

Onderdelen

Geen onderdelen nodig.

  1. Remove wrist strap and battery.
    • Remove wrist strap and battery.

    Voeg opmerking toe

  2. Remove 2 screws from each side of the camera (4 total, 0.102 in).
    • Remove 2 screws from each side of the camera (4 total, 0.102 in).

    • Remove 2 screws from the bottom on the camera (0.138 in).

    • Do not mix the 4 side screws with the 2 bottoms ones; they are different sizes.

    Voeg opmerking toe

    • Gently pull off the front cover.

    • The plate on the side should come off.

    • Gently pull off the back cover.

    Voeg opmerking toe

    • The cases should now be removed.

    This can be a bit tricky when reassembling. All of the little tabs around the edge need to snap into their proper places, and there are three cover pieces to manage. Plus, you need to make sure that the camera/video/playback switch is properly engaged with its slider on the circuit board, otherwise you'll need to raise the back panel and reposition everything again.

    Craig Bonsignore - Antwoord

    oh yes , i agree lol

    elbala80 -

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use the spudger to disconnect the black tab.

    Voeg opmerking toe

    • Gently pull off the shutter button assembly.

    Voeg opmerking toe

    • Use the tweezers to disconnect the microphone cable.

    Voeg opmerking toe

    • The shutter button assembly should now be removed.

    Voeg opmerking toe

    • With the spudger, flip up the black tab on the main ribbon.

    Voeg opmerking toe

    • Gently pull straight out on the ribbon to disconnect it from the logic board.

    Voeg opmerking toe

    • By hand, gently unfold the function button board and lift it off the frame.

    Voeg opmerking toe

    • Congratulations! The function button board can now be replaced.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Wyatt Chan

Lid sinds: 05-01-11

235 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 3-32, Regan Winter 2011 Lid van Cal Poly, Team 3-32, Regan Winter 2011

CPSU-REGAN-W11S3G32

3 Leden

8 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 1

Altijd: 1,792