Canon PowerShot G3 Speaker Replacement

Inleiding

Replacing the speaker in the Canon PowerShot G3 is not a difficult task, but can take some time to disassemble and reassemble the camera.

Note: There are many screws to be removed before you can reach the speaker. It is advised to not continue until you have a magnetic pad to place the screws on.

Wat je nodig hebt

Stap 1 Speaker

Canon PowerShot G3 Speaker Replacement, Speaker: stap 1, afbeelding 1 van 1

Start to remove the screws around the camera: from the front, back, sides, and bottom.

Bewerken

Stap 2

Once the screws are removed, remove the back panel. The panel should be able to be removed by hand.

Bewerken

Stap 3

Next remove the front and right side panels (the left is attached to the front panel).

Bewerken

Stap 4

Finally, remove the top panel as shown.

Bewerken

Stap 5

The front of the camera should now resemble the picture shown. (Image 1)
Remove the capacitor/speaker housing using your finger nail or other thin object to lift it up around the edges. (Image 2)

Bewerken

Stap 6

To remove the circuit ribbon (brown strip) pull it out of the plastic piece it is connected to.

Bewerken

Stap 7

You should now be able to see how the capacitor/speaker housing slides out of the frame.

Bewerken

Stap 8

Disconnect the speaker wires from the camera, then use a small flat head screw driver to lift the speaker out of its housing.
Order a new speaker from the manufacturer or take it to a local electronics store to see if they have one.

Bewerken