Inleiding

If your battery notch is stuck, or even broken, then follow this guide to replace the notch. All it takes is some hard work, a few tools, and the right attitude.

Locate the side of camera with the HDMI port. Unscrew the 7mm with a #00 Phillips screw driver.
  • Locate the side of camera with the HDMI port.

  • Unscrew the 7mm with a #00 Phillips screw driver.

Voeg opmerking toe

Use your fingers to gently detach the plastic component from the camera Use your fingers to gently detach the plastic component from the camera
  • Use your fingers to gently detach the plastic component from the camera

Voeg opmerking toe

Unscrew the bottom three 4mm screws with a #00 Phillips screwdriver. Unscrew the bottom three 4mm screws with a #00 Phillips screwdriver. Unscrew the bottom three 4mm screws with a #00 Phillips screwdriver.
  • Unscrew the bottom three 4mm screws with a #00 Phillips screwdriver.

Voeg opmerking toe

Unscrew the inner 4mm screw with a #00 Phillips screwdriver.
  • Unscrew the inner 4mm screw with a #00 Phillips screwdriver.

Voeg opmerking toe

Unscrew the top 7mm screw on the right side of the camera. Unscrew the bottom 4 mm screw on the right side of the camera.
  • Unscrew the top 7mm screw on the right side of the camera.

  • Unscrew the bottom 4 mm screw on the right side of the camera.

Voeg opmerking toe

Use the plastic opening tool to pry open the entire back panel. Use your fingers to pull off the back panel. Use your fingers to pull off the back panel.
  • Use the plastic opening tool to pry open the entire back panel.

  • Use your fingers to pull off the back panel.

Voeg opmerking toe

Now that the panel is off, unscrew the 9mm screw holding the battery notch in. Use the pliers (or your fingers) to take off the white notch. There is a spring underneath the battery notch. Do not lose this spring or let it fall off.
  • Now that the panel is off, unscrew the 9mm screw holding the battery notch in.

  • Use the pliers (or your fingers) to take off the white notch.

    • There is a spring underneath the battery notch. Do not lose this spring or let it fall off.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Jonathan Lin

Lid sinds: 14-04-14

512 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 3-41, Maness Spring 2014 Lid van Cal Poly, Team 3-41, Maness Spring 2014

CPSU-MANESS-S14S3G41

4 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 4

Afgelopen 30 Dagen: 15

Altijd: 1,599