Inleiding

This guide shows you how to install the top panel of the camera.

Onderdelen

Geen onderdelen nodig.

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
  • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

Voeg opmerking toe

Using your finger, peel back the textured grip so the components are separated.
  • Using your finger, peel back the textured grip so the components are separated.

Voeg opmerking toe

  • Using the flat end of a spudger, loosen the connection between the front panel and the device.

  • Remove the front panel using your hands.

Voeg opmerking toe

  • Turn Camera over.

  • Using a #00 Phillips screw driver, unscrew the two 4.9 mm Phillips screws located on either side of the viewfinder.

Voeg opmerking toe

  • Using a #00 Phillips screw driver, unscrew the one 5.7 mm Phillips screw located next to the LCD screen.

Voeg opmerking toe

  • Lay the camera on its back.

  • Unsolder the flash connection from the motherboard as noted by the blue circle.

Voeg opmerking toe

  • Remove the top panel by lifting it from the back, pushing it forward over the camera and letting it rotate down in front of the camera.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Zach

Lid sinds: 04-04-12

40 Reputatie

8 handleidingen geschreven

Team

Cal Poly, Team 14-9, Forte Spring 2012 Lid van Cal Poly, Team 14-9, Forte Spring 2012

CPSU-FORTE-S12S14G9

5 Leden

12 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 1,397