Inleiding

Taking off the top of the camera allows repair access to the eye piece and command dial.

Onderdelen

Geen onderdelen nodig.

  1. Open up the battery door.
    • Open up the battery door.

    Voeg opmerking toe

  2. Remove the batteries from the camera by sliding them out into your palm.
    • Remove the batteries from the camera by sliding them out into your palm.

    Voeg opmerking toe

    • Release the side latch to open the back panel.

    Voeg opmerking toe

    • Remove the two black 4.5mm screws above and below the latch.

    Voeg opmerking toe

    • Using your finger, carefully pry open the side panel from the top of camera.

    • Pull panel downwards to remove.

    • Make sure to keep track of the small black piece of rubber under the latch.

    Voeg opmerking toe

    • Remove the two silver 6mm Phillips #1 screws.

    Voeg opmerking toe

    • Flip camera over to the bottom.

    • Remove the one 5mm Phillips #1 silver screw.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Remove the front panel by pulling away from the side with the lever.

    Voeg opmerking toe

    • Remove three black 7.3mm Phillips #1 screws located on the corners of the camera.

    • Remove five black 4.8mm Phillips #1 screws.

    Voeg opmerking toe

    • Simply remove the bottom panel by prying it off with your finger.

    • When removing the panel, be sure the bottom of the camera is facing upright. There are loose gears that may fall out.

    • Be wary of a loose piece of foam attached to the bottom panel.

    Voeg opmerking toe

    • Remove the remote control socket cover.

    Voeg opmerking toe

    • Remove two black 4.5mm Phillips #1 screws.

    Voeg opmerking toe

    • Remove two black 4.8mm Phillips #1 screws on the front of the camera.

    Voeg opmerking toe

    • Pry open the side grip using a spudger.

    Voeg opmerking toe

    • With your hands, remove the rubber grip from the eye piece.

    Voeg opmerking toe

    • Remove the eyecup from the eyepiece by pushing the eyecup up.

    Voeg opmerking toe

    • Remove two silver 5.0mm Phillips #1 screws.

    Voeg opmerking toe

    • Remove the silver 5.5mm Phillips #1 screw.

    Voeg opmerking toe

    • Pry the top silver part of the camera off.

    • Buttons may slip out of the camera's top as the top is pulled off the camera (shown in picture two).

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Tammy Kong

Lid sinds: 23-01-14

643 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 6-20, Maness Winter 2014 Lid van Cal Poly, Team 6-20, Maness Winter 2014

CPSU-MANESS-W14S6G20

4 Leden

11 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 2

Afgelopen 30 Dagen: 9

Altijd: 300