Inleiding

In this guide we will replace the power cord and the transformer The transformer is the large, heavy device that converts the relatively high 220V input voltage into a lower voltage for the amplifier.

Remove 2 screws from each side of the amplifier.
  • Remove 2 screws from each side of the amplifier.

Voeg opmerking toe

Remove 2 screws on rear of device. Slide top cover up and back from main case.
  • Remove 2 screws on rear of device. Slide top cover up and back from main case.

Voeg opmerking toe

Mac RAM Kits
Versnel je Mac. Breid zijn geheugen uit.
Mac RAM Kits
Haal meer megabytes uit je Mac.
Remove 3 screws on bottom of case. Remove 13 screws on rear panel.
  • Remove 3 screws on bottom of case.

  • Remove 13 screws on rear panel.

    • Do not move the rear panel too far, as the power cord is still connected.

Voeg opmerking toe

Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.
  • Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.

  • It may require some wiggling, but it should slip out of the hole and then off of the cord.

Voeg opmerking toe

Carefully de-solder ends of power cord from circuit board.
  • Carefully de-solder ends of power cord from circuit board.

  • Keep track of the colors of the cords. The brown cord leads to the L on the circuit board, and this cord will lead to a fuse in the power plug. The blue cord leads to the N on the board.

  • Finally, pull the power cord through the rear panel to completely remove it.

Voeg opmerking toe

To remove the transformer the motherboard must be removed. This is to gain access to the solder on the power cords. -See guide for removing motherboard.
  • To remove the transformer the motherboard must be removed. This is to gain access to the solder on the power cords. -See guide for removing motherboard.

  • Remove the 4 nuts holding down the transformer bracket using a 7mm nut driver or socket.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Colby

Lid sinds: 15-04-10

284 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 28-36, Regan Spring 2010 Lid van Cal Poly, Team 28-36, Regan Spring 2010

CPSU-REGAN-S10S28G36

4 Leden

3 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 3

Afgelopen 30 Dagen: 22

Altijd: 5,533