Inleiding

Follow this guide to install the trackball in the Blackberry Pearl 8100.

Onderdelen

Geen onderdelen nodig.

  1. Before working on the phone, be sure that the phone is turned off.
    • Before working on the phone, be sure that the phone is turned off.

    • Begin by removing the back panel; this can be done by pressing the silver button on the backside of the Blackberry 8100, while simultaneously sliding the back panel off.

    Voeg opmerking toe

    • Remove the battery located directly below back panel.

    Voeg opmerking toe

    • Using a 1.5 mm Hex screwdriver, remove the two screws that hold the two panels together.

    Voeg opmerking toe

    • Using the spudger, pry off the small portion of the casing located at the bottom of the phone.

    Voeg opmerking toe

    • Using the spudger, pry off the side casings one at a time by wedging it between the inner casing and the sides.

    Voeg opmerking toe

    • Using a 1.5mm Hex screwdriver, unscrew the two screws, located on the front of the phone, that connect the back and front panels.

    Voeg opmerking toe

    • Using the spudger, pry off the back body panel by wedging the spudger in between the front and back panels on the side face. Remove the back body panel.

    Voeg opmerking toe

    • Separate the logic board from the front panel.

    Voeg opmerking toe

    • Gently remove the keyboard from front casing. It should snap out of place.

    Voeg opmerking toe

    • Remove the larger chrome ring holding the track ball in place by using the spudger to gently wedge the top ring away, approaching from the front face.

    • Some of these parts are fairly small and fragile; be sure to keep them in a safe place where they won't be damaged if you intend to reuse them.

    Voeg opmerking toe

    • Remove the smaller chrome inner ring surrounding the trackball; it should be able to be simply lifted by hand.

    Voeg opmerking toe

    • Remove the trackball housing; it should be able to be removed by hand.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Robert Cronin

Lid sinds: 08-04-10

520 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 34-57, Forte Spring 2010 Lid van Cal Poly, Team 34-57, Forte Spring 2010

CPSU-FORTE-S10S34G57

5 Leden

6 handleidingen geschreven

Één commentaar

why dissasemble the entire device, just remove the chrome ring....

Latios Eon - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 3

Altijd: 7,509