Ga door naar hoofdinhoud

Inleiding

Outline what you are going to teach someone how to do.

Onderdelen

Geen onderdelen opgegeven.

  1. Before beginning this installation, make sure phone is powered off . Turn phone over to the backside. Press down on the lower portion of the back cover.
    • Before beginning this installation, make sure phone is powered off .

    • Turn phone over to the backside.

    • Press down on the lower portion of the back cover.

    • Slide the lower portion down to remove the cover and reveal the battery.

  2. Remove the battery from the phone.
    • Remove the battery from the phone.

  3. PC Laptop batterijen

    An easy fix for a big power boost.

    Nu winkelen

    PC Laptop batterijen

    An easy fix for a big power boost.

    Nu winkelen
  4. Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver. Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver.
    • Once the battery is removed, remove the four 9.2 mm screws with the T4 Torx Screwdriver.

  5. Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool. Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool. Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool.
    • Remove side panels with the Plastic Opening Tool by sliding it along the edge of the panel until you can pry it off with the tool.

  6. Remove the back casing using the Plastic Opening Tool Once the back casing is removed the top two buttons are likely to pop out.
    • Remove the back casing using the Plastic Opening Tool

    • Once the back casing is removed the top two buttons are likely to pop out.

  7. Locate the two 9.2mm screws on the upper inside casing Remove them using the T4 Torx Screwdriver Slide off the front casing once the screws are removed.
    • Locate the two 9.2mm screws on the upper inside casing

    • Remove them using the T4 Torx Screwdriver

    • Slide off the front casing once the screws are removed.

    • Trackball will fall out once the casing is removed.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Martha de Maria y Campos

Lid sinds: 12-04-12

55 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 17-27, Amido Spring 2012 Lid van Cal Poly, Team 17-27, Amido Spring 2012

CPSU-AMIDO-S12S17G27

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 2

Altijd: 524