Inleiding

Need to get inside your Blackberry Storm to fix it? Or just want to salvage parts? This is an easy to follow guide to do it!

Have a cracked screen? Need to replace your speaker? Etc? Well just follow these steps.
  • Have a cracked screen? Need to replace your speaker? Etc? Well just follow these steps.

Voeg opmerking toe

Turn your Storm where the battery door is facing up. Remove the battery door. Remove the battery.
  • Turn your Storm where the battery door is facing up.

  • Remove the battery door.

  • Remove the battery.

Voeg opmerking toe

Remove the two hex screws as shown by the SIM card slot.
  • Remove the two hex screws as shown by the SIM card slot.

Voeg opmerking toe

Remove the plastic piece that covers the camera & flash on the back . This is held in with some tape so use a safe pry tool. Remove the two hex screws underneath it.
  • Remove the plastic piece that covers the camera & flash on the back . This is held in with some tape so use a safe pry tool.

  • Remove the two hex screws underneath it.

Voeg opmerking toe

Turn the phone over and remove the plastic cover under the buttons as shown. Remove the 2 screws underneath. Remove the 2 screws underneath.
  • Turn the phone over and remove the plastic cover under the buttons as shown.

  • Remove the 2 screws underneath.

Voeg opmerking toe

Go around your device with the plastic pry tool, there a 3 clips on each side of the housing. There is a connection for the antenna from the front to mid housing. Remove it with a pry tool if it does not come off by itself. There is a connection for the antenna from the front to mid housing. Remove it with a pry tool if it does not come off by itself.
  • Go around your device with the plastic pry tool, there a 3 clips on each side of the housing.

  • There is a connection for the antenna from the front to mid housing. Remove it with a pry tool if it does not come off by itself.

Voeg opmerking toe

You now have 3 pieces. The rear, mid , & front housing.
  • You now have 3 pieces. The rear, mid , & front housing.

Voeg opmerking toe

To remove the screen gently pry up this ribbon cable with a pry tool. To remove the screen gently pry up this ribbon cable with a pry tool.
  • To remove the screen gently pry up this ribbon cable with a pry tool.

Voeg opmerking toe

To remove the main board from the mid housing disconnect the ribbon cable as pictured. Now follow in reverse order for reassembly! Now follow in reverse order for reassembly!
  • To remove the main board from the mid housing disconnect the ribbon cable as pictured.

  • Now follow in reverse order for reassembly!

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

6 andere personen hebben deze handleiding voltooid.

Josh Forester

Lid sinds: 28-11-10

2.306 Reputatie

10 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 1

Altijd: 9,351