Inleiding

This is a guide on how to replace the logic board on your Blackberry 7510.

Onderdelen

Geen onderdelen nodig.

Remove the battery cover and battery before continuing.
  • Remove the battery cover and battery before continuing.

  • Remove the six T6 Torx screws on the back of the phone.

  • Make sure to keep the screws somewhere that they will not get lost.

Voeg opmerking toe

Using your finger nail or a spudger, carefully pry up the back cover.
  • Using your finger nail or a spudger, carefully pry up the back cover.

  • Begin in one spot and slowly circle around the device as you pry up all of the back cover.

Voeg opmerking toe

  • Lift off the back cover.

Voeg opmerking toe

  • Remove the two T6 screws.

Voeg opmerking toe

  • Remove the daughterboard.

  • Remove the exposed vibration motor.

Voeg opmerking toe

  • Using the T6 Torx screwdriver, remove the top screw.

Voeg opmerking toe

  • Using your spudger, carefully pry off back plate.

  • Use the same technique as with the plastic back cover. Circle around the back plate until all of it is pried up.

Voeg opmerking toe

  • Remove the front cover and keypad.

Voeg opmerking toe

  • Remove one T6 Torx screw in the front bottom right of the board.

Voeg opmerking toe

  • Carefully pry the screen from the board with your spudger.

  • After prying it up, remove the screen from the board.

Voeg opmerking toe

  • Unscrew center T6 Torx screw in the center of the logic board.

  • Remove the logic board from the phone.

  • Replace with new logic board.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Neil Johnson

Lid sinds: 24-01-10

12 Reputatie

6 handleidingen geschreven

Team

Cal Poly, Team 14-44, Regan Winter 2010 Lid van Cal Poly, Team 14-44, Regan Winter 2010

CPSU-REGAN-W10S14G44

4 Leden

8 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 1,781