Before disassembling the blender base, make sure the blender disconnected from any power outlet. Lift the jar straight up from the base without tilting the jar.
  • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

  • Lift the jar straight up from the base without tilting the jar.

Voeg opmerking toe

Remove the top three 1/4 inch base screws using a Philip's head screwdriver.
  • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

Voeg opmerking toe

Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver. This provides access to the base screws beneath.
  • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

  • This provides access to the base screws beneath.

Voeg opmerking toe

Mac RAM Kits
Versnel je Mac. Breid zijn geheugen uit.
Mac RAM Kits
Haal meer megabytes uit je Mac.
Remove the following screws that secure the top and  bottom halves of the base.
  • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

  • Both screwdrivers must have a minimum of a three inch shank (length).

  • Screwdrivers with extenders will not fit down the access holes.

Voeg opmerking toe

Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.
  • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

Voeg opmerking toe

Once you have the base removed, the circuit board should be clearly visible inside.
  • Once you have the base removed, the circuit board should be clearly visible inside.

Voeg opmerking toe

Remove the four screws located on the circuit board. Two are on the left side.
  • Remove the four screws located on the circuit board.

    • Two are on the left side.

    • Two are on the right side.

Voeg opmerking toe

Remove the following soldered connections with a soldering iron:
  • Remove the following soldered connections with a soldering iron:

    • Motor wires

    • Power cord wires

Voeg opmerking toe

Lift the circuit board straight up to remove it from the base.
  • Lift the circuit board straight up to remove it from the base.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Andrew

Lid sinds: 04-10-12

170 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 6-34, Regan Fall 2012 Lid van Cal Poly, Team 6-34, Regan Fall 2012

CPSU-REGAN-F12S6G34

4 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 3

Afgelopen 7 Dagen: 10

Afgelopen 30 Dagen: 37

Altijd: 2,531