Ga door naar hoofdinhoud

Inleiding

Do you have an old bike that needs to be restored? A bike’s chainring is one of many things that can be easily worn down as bikes age. A chainring connects the bike chain to the rear wheel of the bike. Restore a bike’s old chainring by replacing it with a new chainring.

Onderdelen

  1. Unscrew both nuts on opposite sides of the rear wheel with the 15 mm wrench until the wheel loosens from the bike frame.
    • Unscrew both nuts on opposite sides of the rear wheel with the 15 mm wrench until the wheel loosens from the bike frame.

    • Loosen the nuts with the 15 mm wrench and continue unscrewing the nuts with your hands.

    • Push the rear wheel forward until enough slack is given on the chain.

  2. With the slack previously made, remove the chain off the chainring. Touching the chain isn't dangerous, but it will be dirty.
    • With the slack previously made, remove the chain off the chainring.

    • Touching the chain isn't dangerous, but it will be dirty.

  3. Locate chainring, the gear connected to the pedals. Place the spanner tool on the backside of the 6.5 mm chainring bolt. The spanner will be used to keep the bolts in place while unscrewing them on the opposite sides.
    • Locate chainring, the gear connected to the pedals.

    • Place the spanner tool on the backside of the 6.5 mm chainring bolt. The spanner will be used to keep the bolts in place while unscrewing them on the opposite sides.

    • On the chainring there will be one bolt facing the opposite direction, usually the bolt blocked by the pedal. Adjust for this by swapping use of the hex key and spanner tool.

  4. PC Laptop batterijen

    Een snelle fix voor een grote boost.

    Nu winkelen

    PC Laptop batterijen

    Een snelle fix voor een grote boost.

    Nu winkelen
  5. With the spanner tool on one side of the chainring, use a 5 mm hex key to remove the chainring bolts on the opposite side.
    • With the spanner tool on one side of the chainring, use a 5 mm hex key to remove the chainring bolts on the opposite side.

    • Repeat with the rest of the bolts.

  6. Use clean paper towels to wipe off the chainring bolts. Make sure to wipe off all the dirt and grease you can.
    • Use clean paper towels to wipe off the chainring bolts. Make sure to wipe off all the dirt and grease you can.

    • Clean thoroughly within the threads.

  7. Now that the chainring bolts are clean, apply a pea-sized amount of grease to each bolt.
    • Now that the chainring bolts are clean, apply a pea-sized amount of grease to each bolt.

  8. Use your fingers to evenly spread a coat the grease around the entire bolt.
    • Use your fingers to evenly spread a coat the grease around the entire bolt.

    • If the chainring bolts contain rust, it is recommended to replace the bolts with a new set.

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Jeffrey Tang

Lid sinds: 24-02-15

331 Reputatie

1 Handleiding geschreven

Team

Cal Poly, Team 23-5, Green Winter 2015 Lid van Cal Poly, Team 23-5, Green Winter 2015

CPSU-GREEN-W15S23G5

4 Leden

3 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 5

Afgelopen 30 Dagen: 54

Altijd: 1,909