Ga door naar hoofdinhoud

Back Panel

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. Back Panel, Back Panel: stap 1, afbeelding 1 van 2 Back Panel, Back Panel: stap 1, afbeelding 2 van 2
    • Using a Torx T6 Screwdriver, remove the ten 7mm screws from the back panel.

  2. Back Panel: stap 2, afbeelding 1 van 3 Back Panel: stap 2, afbeelding 2 van 3 Back Panel: stap 2, afbeelding 3 van 3
    • Using a metal spudger, pry the device apart.

    • To recombine them, line up the two halves of the device and press them together.

  3. Back Panel: stap 3, afbeelding 1 van 1
    • Turn the device over, laying it on its back with the screen facing upwards.

    • Lift the front panel away from the silver part of the back panel.

    • Make sure not to rip the ribbon cable that is connected to the screen and the motherboard.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Ryan Williams

Lid sinds: 09/28/16

763 Reputatie

6 handleidingen geschreven

Team

USF Tampa, Team 4-2, Passmore Fall 2016 Lid van USF Tampa, Team 4-2, Passmore Fall 2016

USFT-PASSMORE-F16S4G2

4 Leden

6 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 32