Ga door naar hoofdinhoud

Back Cover Replacement

Wat je nodig hebt

  1. Back Cover Replacement, Back Cover: stap 1, afbeelding 1 van 1
    • Power off Zoomer Dino Boomer before disassembly.

    • Remove the eight 9.3mm Phillips #1 screws.

  2. Back Cover Replacement: stap 2, afbeelding 1 van 2 Back Cover Replacement: stap 2, afbeelding 2 van 2
    • Turn dinosaur over and hold upright.

    • Use the spudger to pry apart the back cover from the remainder of the Zoomer Dino Boomer.

    • Be gentle while removing the back cover. The back cover of the Zoomer Dino Boomer is still connected to the electronic system by a wire.

  3. Back Cover Replacement: stap 3, afbeelding 1 van 3 Back Cover Replacement: stap 3, afbeelding 2 van 3 Back Cover Replacement: stap 3, afbeelding 3 van 3
    • Disconnect the wire that connects the back cover of the dino to the main circuit board by carefully pulling on the orange wire connector with tweezers.

    • Remove back cover.

    • If you are having difficulty removing the connector from its socket, push in the small tabs on the side of the connector with the tweezers. This step may take some work.

    • Do not damage the wires or circuit board.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Desiree DesJardins

Lid sinds: 09/02/15

452 Reputatie

2 handleidingen geschreven

Team

USF Tampa, Team 16-1, Wollert Fall 2015 Lid van USF Tampa, Team 16-1, Wollert Fall 2015

USFT-WOLLERT-F15S16G1

3 Leden

10 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 5

Altijd: 676