Aquarium Top Filter Box Replacement

Inleiding

Use this guide to replace a cracked or broken filter box with a regular plastic box. This guide will provide you with the instructions and tools to repair your aquarium top filter. The added benefit you can achieve from this guide is that you can customize the filtration system best suited for your aquarium. The tools listed in this guide are easily accessible and can be found online or in any hardware store.

Wat je nodig hebt

Stap 1 Aquarium Filter Box

Aquarium Top Filter Box Replacement, Aquarium Filter Box: stap 1, afbeelding 1 van 2

Aquarium Top Filter Box Replacement, Aquarium Filter Box: stap 1, afbeelding 2 van 2

Using a black sharpie marker, mark the box for accurate holes.
Make sure the hole is a little bit smaller than the soft PVC pipe.

Bewerken

Stap 2

Use the utility knife to cut a hole in the marked position to attach the pipe.
Be very careful as the box is difficult to cut.

Bewerken

Stap 3

Using the same utility knife, make a hole in the bottom of the plastic box for the water to come out.
Be very careful as the box is difficult to cut.

Bewerken

Stap 4

Attach the soft PVC pipe with the aquarium powerhead.
Make sure it is properly connected.

Bewerken

Stap 5

Insert the soft PVC pipe in the plastic box.

Bewerken

Stap 6

Aquarium Top Filter Box Replacement: stap 6, afbeelding 3 van 3

With a telfon tape properly wrap the soft PVC pipe for no leakage of water.

Bewerken

Stap 7

Aquarium Top Filter Box Replacement: stap 7, afbeelding 3 van 3

Use aquarium-safe silicone glue to seal the soft PVC pipe with the plastic box.
Make sure to let the silicone glue dry for 30 minutes.

Bewerken

Stap 8

Aquarium Top Filter Box Replacement: stap 8, afbeelding 3 van 3

Add your desired filter media best suited for your aquarium.
Finally, submerge the waterpump in water and adjust the waterflow.
Be careful were you place the inlet of the filter, so no organisms or substrate get sucked in and die inside or clog it. If needed you can put some filter floss or a sponge on the inlet to prevent the above.