Ga door naar hoofdinhoud

Inleiding

Replacing the back pad is necessary for future replacements for this device.

Onderdelen

Geen onderdelen opgegeven.

  1. CAUTION: The heat gun and hair dryer can get very hot. Do not put your hands or any other body part too close to either device. Also, do not touch the back pad right after heating it.
    • CAUTION: The heat gun and hair dryer can get very hot. Do not put your hands or any other body part too close to either device. Also, do not touch the back pad right after heating it.

    • Use a blow dryer or heat gun on a medium to high heat setting on the back pad to loosen the glue that attaches it to the device.

  2. Koop geen nieuw model.

    Bespaar $10 op $50 met coupon
    SKIPANDSAVE10

    Bespaar nu

    Koop geen nieuw model.

    Take $10 off $50 with
    SKIPANDSAVE10

    Bespaar nu
  3. To avoid ripping the back pad, gently peel it back from one corner until the pad is completely off.
    • To avoid ripping the back pad, gently peel it back from one corner until the pad is completely off.

    • Use heat in areas where the glue is not loose enough.

    • You may need to reattach the back pad with double-sided tape if the glue is not tacky enough to stick the pad back on.

Conclusie

To reassemble your device, follow these instructions in reverse order without using the hair dryer.

Jada Evers

Lid sinds: 14-10-14

271 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 10-37, Amido Fall 2014 Lid van Cal Poly, Team 10-37, Amido Fall 2014

CPSU-AMIDO-F14S10G37

4 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 4

Afgelopen 30 Dagen: 12

Altijd: 1,312