Onderdelen

Geen onderdelen nodig.

Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.
  • Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.

Voeg opmerking toe

Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.
  • Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.

Voeg opmerking toe

Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing. Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.
  • Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.

Voeg opmerking toe

Unplug the black connector on the top of the metal casing by gently pulling horizontally.
  • Unplug the black connector on the top of the metal casing by gently pulling horizontally.

Voeg opmerking toe

Remove four 1mm phillips screws from the bottom.
  • Remove four 1mm phillips screws from the bottom.

Voeg opmerking toe

Separate the top and bottom of the metal casing. You will now expose the motherboard and AirPort card.
  • Separate the top and bottom of the metal casing. You will now expose the motherboard and AirPort card.

  • To remove the AirPort card, gently pull the plastic tab horizontally.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

3 andere personen hebben deze handleiding voltooid.

Michael Garcia

Lid sinds: 12-10-11

369 Reputatie

5 handleidingen geschreven

Team

Cal Poly, Team 17-15, Regan Fall 2011 Lid van Cal Poly, Team 17-15, Regan Fall 2011

CPSU-REGAN-F11S17G15

3 Leden

7 handleidingen geschreven

Één commentaar

Thank you so much for your guide! I was challenging myself to do it without cheating, but couldn't figure out how to release the bottom plastic layer from the main unit inside after I undid the 3 Torx screws. Thankfully you avoided me having to break the whole unit by showing where the central screw hidden beneath the S/N 3 barcode sticker was and that it was Philips not Torx, and I can now pinch the A1027 wifi card and use it in my G5, instead of relying on ageing ethernet! Bless you kind folks!

HumptyDumpty - Antwoord

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 12

Altijd: 4,479