Ga door naar hoofdinhoud

Anker 2.4G Wireless Mouse LED Replacement

Wat je nodig hebt

  1. Anker 2.4G Wireless Mouse LED Replacement, LED: stap 1, afbeelding 1 van 1
    • Use a spudger to gently pry off the stickers to reveal the location of the four screws.

  2. Anker 2.4G Wireless Mouse LED Replacement: stap 2, afbeelding 1 van 1
    • Remove the four screws to continue.

  3. Anker 2.4G Wireless Mouse LED Replacement: stap 3, afbeelding 1 van 2 Anker 2.4G Wireless Mouse LED Replacement: stap 3, afbeelding 2 van 2
    • Pry the center of the mouse apart using a spudger to separate the upper and lower housing of the boards.

  4. Anker 2.4G Wireless Mouse LED Replacement: stap 4, afbeelding 1 van 1
    • Remove the wires from the white crimp headers. This will separate the upper and lower housing units of the mouse.

    • Pull as far up on the wire as possible, but be careful to avoid ripping the wires.

  5. Anker 2.4G Wireless Mouse LED Replacement: stap 5, afbeelding 1 van 2 Anker 2.4G Wireless Mouse LED Replacement: stap 5, afbeelding 2 van 2
    • Take the upper housing of the mouse and remove the two screws that hold the board in place.

  6. Anker 2.4G Wireless Mouse LED Replacement: stap 6, afbeelding 1 van 1
    • Gently remove the circuit board from the mouse.

  7. Anker 2.4G Wireless Mouse LED Replacement: stap 7, afbeelding 1 van 1
    • To remove the LED, flip the board over and desolder the wires.

    • Replace LED with a new LED and resolder into place.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Colin

Lid sinds: 02/10/14

406 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 1-39, Maness Winter 2014 Lid van Cal Poly, Team 1-39, Maness Winter 2014

CPSU-MANESS-W14S1G39

4 Leden

16 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 14

Altijd: 2,871