Menu

Jouw instellingen

Mijn werkbank

Krijg snel toegang tot handleidingen, onderdelen en antwoorden voor jouw apparaten
Winkelwagen

Het lijkt erop dat je mandje leeg is

Doorblader onze winkel

Andis 1875-Watt Fold-N-Go Ionic Hair Dryer Outer Casing Replacement

Geschreven door: Scott Havard (en een andere inzender)
  • Reacties: 1
  • Favorieten: 0

Moeilijkheid

Gemiddeld

Stappen

7

Tijd vereist

Stel een tijd voor??

Secties

1

Markeringen

0

Inleiding

No-one likes hot air coming from broken plastic. Use this guide to replace the outer casing of your Andis Fold-N-Go Hair Dryer to keep hot air in a happy home.

Gereedschap

Koop deze gereedschappen

Onderdelen

Geen onderdelen opgegeven.

  1. Remove the two Phillips #00 screws:

    • Remove the two Phillips #00 screws:

    • One Phillips 16mm screw

    • One Phillips 14 mm screw

    • All of the hair dryer's components are held together by these two screws. Parts may quickly separate after screw removal. Tape can be used to hold everything in place.

    Bewerken

  2. Remove the top portion of the handle. The model information and warnings are engraved on the top portion. The model information and warnings are engraved on the top portion.

    • Remove the top portion of the handle.

    • The model information and warnings are engraved on the top portion.

    Bewerken

  3. Remove the settings switch by lifting straight up. Remove the settings switch by lifting straight up.

    • Remove the settings switch by lifting straight up.

    Bewerken

  5. Remove the internal components from the rear portion of the handle. Remove the switch Remove the circuitboard

    • Remove the internal components from the rear portion of the handle.

    • Remove the switch

    • Remove the circuitboard

    • Remove the capacitor in black plastic

    • These parts are not secured to the handle by anything, but are all connected to each other by wires. They shouldn't be difficult to remove, but remember that they will come out together.

    Bewerken

  6. Remove the sliding black cover at the top of the handle. Remove the sliding black cover at the top of the handle. Remove the sliding black cover at the top of the handle.

    • Remove the sliding black cover at the top of the handle.

    Bewerken

  7. Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle. Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle.

    • Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle.

    Bewerken

  8. Separate the silver front casing from the black rear vent. Separate the silver front casing from the black rear vent.

    • Separate the silver front casing from the black rear vent.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

Auteur

met 1 andere bijdrager

Scott Havard

Lid sinds: 27-06-16

33.931 Reputatie

33 handleidingen geschreven

Badges: 38

+35 andere badges

0 Opmerkingen

Een opmerking toevoegen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 4

Afgelopen 30 Dagen: 22

Altijd: 1,100