Ga door naar hoofdinhoud

American Sanders EZSand Orbital Sander 07163A 2012 Sanding Disc Assembly Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. American Sanders EZSand Orbital Sander 07163A 2012 Sanding Disc Assembly Replacement, Remove the sanding disc: stap 1, afbeelding 1 van 3 American Sanders EZSand Orbital Sander 07163A 2012 Sanding Disc Assembly Replacement, Remove the sanding disc: stap 1, afbeelding 2 van 3 American Sanders EZSand Orbital Sander 07163A 2012 Sanding Disc Assembly Replacement, Remove the sanding disc: stap 1, afbeelding 3 van 3
    • Use a flathead screwdriver to pry off and remove the rubber plug in the center of the sanding disc.

  2. American Sanders EZSand Orbital Sander 07163A 2012 Sanding Disc Assembly Replacement: stap 2, afbeelding 1 van 2 American Sanders EZSand Orbital Sander 07163A 2012 Sanding Disc Assembly Replacement: stap 2, afbeelding 2 van 2
    • Slide a thin 22 mm wrench underneath the sanding disc and clasp it onto the flat part of the motor driveshaft to keep the driveshaft from turning.

  3. American Sanders EZSand Orbital Sander 07163A 2012 Sanding Disc Assembly Replacement: stap 3, afbeelding 1 van 2 American Sanders EZSand Orbital Sander 07163A 2012 Sanding Disc Assembly Replacement: stap 3, afbeelding 2 van 2
    • Use an 11 mm socket and socket wrench to remove the 16.5 mm-long bolt securing the sanding disc to the motor driveshaft.

    • Apply counter torque to the driveshaft wrench as you loosen the bolt to keep the sanding disc from spinning.

  4. American Sanders EZSand Orbital Sander 07163A 2012 Sanding Disc Assembly Replacement: stap 4, afbeelding 1 van 3 American Sanders EZSand Orbital Sander 07163A 2012 Sanding Disc Assembly Replacement: stap 4, afbeelding 2 van 3 American Sanders EZSand Orbital Sander 07163A 2012 Sanding Disc Assembly Replacement: stap 4, afbeelding 3 van 3
    • Take two pry bars and insert them underneath the sanding disc as close to the driveshaft as possible.

    • Apply pressure to the pry bars in opposite directions to carefully pry the sanding disc off of the driveshaft.

    • Remove the sanding disc from the floor sander.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Adam O'Camb

Lid sinds: 04/11/15

195.318 Reputatie

416 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 18