Menu

Jouw instellingen

Mijn werkbank

Krijg snel toegang tot handleidingen, onderdelen en antwoorden voor jouw apparaten
Winkelwagen

Het lijkt erop dat je mandje leeg is

Doorblader onze winkel

Alpine MRV-M500 Electrolytic Capacitor Replacement

Geschreven door: Eric Gaulke (en 2 andere bijdragers)
  • Reacties: 0
  • Favorieten: 0
  • Voltooide reparaties: 1

Moeilijkheid

Zeer moeilijk

Stappen

4

Tijd vereist

1 uur

Secties

1

Markeringen

0

Inleiding

Electrolytic capacitors are electronic components used to store energy. If too much current runs through a capacitor, it may become bulged and need to be replaced. To replace a capacitor on the MRV-M500 you will need previous experience soldering electronics. To learn how to solder, see this guide.

Gereedschap

Koop deze gereedschappen

Onderdelen

  1. Remove all the Phillips 10.0mm and 7.0mm screws on the outside of the case. Make sure the device has been powered off and disconnected from the power source for at least a day before touching the electronic components. Make sure the device has been powered off and disconnected from the power source for at least a day before touching the electronic components.

    • Remove all the Phillips 10.0mm and 7.0mm screws on the outside of the case.

    • Make sure the device has been powered off and disconnected from the power source for at least a day before touching the electronic components.

    Bewerken

  2. Remove all Phillips 7.5mm, 12.5mm, and 10.5mm screws holding the circuit board to the case. Remove the circuit board from the case. Remove the circuit board from the case.

    • Remove all Phillips 7.5mm, 12.5mm, and 10.5mm screws holding the circuit board to the case.

    • Remove the circuit board from the case.

    Bewerken

  3. Gratis verzending van alle bestellingen van meer dan US$ 100 of met een Pro Tech Toolkit!

    Doorblader onze winkel

  4. Find the faulty capacitor. Flip the board over and locate the corresponding pins.

    • Find the faulty capacitor.

    • Flip the board over and locate the corresponding pins.

    • If the faulty capacitor is one of the smaller ones, it may be too difficult to replace and replacing the circuit board itself may be easier.

    • Make sure that the capacitance and voltage rating of the new capacitor match that of the original.

    Bewerken

  5. Desolder the pins to remove the capacitor.

    • Desolder the pins to remove the capacitor.

    • Solder the new capacitor into its place.

    • Make sure the polarity of the new capacitor matches the previous polarity.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Auteur

met 2 andere bijdragers

Eric Gaulke

Lid sinds: 17-09-18

458 Reputatie

3 handleidingen geschreven

Badges: 6

+3 andere badges

Team

Washington State, Team S2-G6, Hope Fall 2018 Lid van Washington State, Team S2-G6, Hope Fall 2018

WSU-HOPE-F18S2G6

4 Leden

3 handleidingen geschreven

0 Opmerkingen

Een opmerking toevoegen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 3

Afgelopen 7 Dagen: 5

Afgelopen 30 Dagen: 22

Altijd: 120