Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Inleiding

Use this guide to replace the volume knob and pitch bender if either of the knobs break, stop working, or get stuck and won't move.

Onderdelen

Geen onderdelen opgegeven.

  1. Remove all the selector knob covers by pulling them off.
    • Remove all the selector knob covers by pulling them off.

  2. Using needle nose pliers, remove the washers from the four corner selector knobs.
    • Using needle nose pliers, remove the washers from the four corner selector knobs.

  3. Flip the device over. Using a Philips #2 screw driver, remove the fourteen 10.3 mm black screws holding the back panel in place.
    • Flip the device over. Using a Philips #2 screw driver, remove the fourteen 10.3 mm black screws holding the back panel in place.

  4. Carefully flip the device to the front making sure you secure the face plate and the chassis together. Please use care in following the step above to avoid ripping the ribbon cables connecting the two sides. Please use care in following the step above to avoid ripping the ribbon cables connecting the two sides.
    • Carefully flip the device to the front making sure you secure the face plate and the chassis together.

    • Please use care in following the step above to avoid ripping the ribbon cables connecting the two sides.

  5. Rotate the device 180 degrees and carefully remove the face plate by slightly lifting the screen side towards you and then sliding the bottom out from under the keys. Use care when doing the step above so that the ribbon connectors which connect the top of the chassis to the top of the face plate are not damaged. Use care when doing the step above so that the ribbon connectors which connect the top of the chassis to the top of the face plate are not damaged.
    • Rotate the device 180 degrees and carefully remove the face plate by slightly lifting the screen side towards you and then sliding the bottom out from under the keys.

    • Use care when doing the step above so that the ribbon connectors which connect the top of the chassis to the top of the face plate are not damaged.

  6. Rotate the device 180 degrees, so that the motherboard is closest to you.
    • Rotate the device 180 degrees, so that the motherboard is closest to you.

    • Take caution to not damage the ribbon cable connecting the face plate to the chassis.

    • Remove the ribbon cable connecting the knobs to the mother board by gently wiggling and pulling it away from the motherboard.

  7. Using a Phillips #2 screwdriver, remove the four 9.5 mm silver screws holding the knobs to the face plate. Using a Phillips #2 screwdriver, remove the four 9.5 mm silver screws holding the knobs to the face plate.
    • Using a Phillips #2 screwdriver, remove the four 9.5 mm silver screws holding the knobs to the face plate.

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Serbinder Singh

Lid sinds: 30-01-13

72 Reputatie

3 handleidingen geschreven

Team

Cal Poly, Team 20-6, Maness Winter 2013 Lid van Cal Poly, Team 20-6, Maness Winter 2013

CPSU-MANESS-W13S20G6

5 Leden

6 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 5

Afgelopen 30 dagen: 15

Altijd: 2,107