Repareer je spullen Gemeenschap Winkel

Adjusting the alarm glass breakage microphone sensitivity

Inleiding

The alarm unit is located behind the glove box. Once the glovebox is out of the way, you can remove the black plastic alarm unit, open it and change the dip switch for a less sensitive setting.

Wat je nodig hebt

  1. Bewerken

  2. Adjusting the alarm glass breakage microphone sensitivity: stap 2, afbeelding 1 van 1

    • Once the glove box is out of the way, it's easy to spot the alarm unit. The green connector will be plugged into it. I had already unplugged it when I took this picture.

    Bewerken

  4. Adjusting the alarm glass breakage microphone sensitivity: stap 3, afbeelding 1 van 1

    • It may be stubborn to get out because it is stuck down with double stick foam pads.

    Bewerken

  5. Adjusting the alarm glass breakage microphone sensitivity: stap 4, afbeelding 1 van 1

    • Remove the 4 screws (may be under the foam strips). This is the bottom of the circuit board.

    Bewerken

  6. Adjusting the alarm glass breakage microphone sensitivity: stap 5, afbeelding 1 van 1

    • Turn the board over and locate the 2 position dip switch.

    • This dip switch adjusts the glass breakage microphone sensitivity

    • Sensitivity settings:

    • 1 off & 2 off = high

    • 1 on & 2 off = mid (factory setting)

    • 1 off & 2 on = low

    • 1 on & 2 on = super low

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

3 andere personen hebben deze handleiding voltooid.

Auteur

met 2 andere bijdragers

mpeeples

Lid sinds: 04/04/10

184 Reputatie

1 Handleiding geschreven

Medailles: 5

+2 andere badges

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 8

Afgelopen 30 dagen: 22

Altijd: 2,566