Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Inleiding

Tablet motherboard's can wear out and sometimes they need to be replaced. This guide walks you through the necessary steps to replace it effectively. The motherboard embedded into this device requires specific tools and techniques to remove and replace it.

    • Reminder: Turn off device before you start opening your tablet.

  1. Begin at any side of the tablet.
    • Begin at any side of the tablet.

    • With a plastic opening tool, begin taking apart the back cover from the tablet by working along the edges.

    • Use caution when prying the lid open to avoid damaging your tablet.

  2. Using a plastic opening tool, separate the back cover from the main device
    • Using a plastic opening tool, separate the back cover from the main device

    • Open each side continuously to ensure all sides have been separated,

  3. Manta schroevendraaierset

    112 bitjes voor elke reparatie.

    Upgrade Your Toolbox

    Manta schroevendraaierset

    Upgrade Your Toolbox
  4. Turn tablet over.
    • Turn tablet over.

    • Lay the tablet on a flat surface with the screen facing down. Locate the copper cover along the outside of the tablet.

  5. Carefully peel back the copper foil to reveal the motherboard.
    • Carefully peel back the copper foil to reveal the motherboard.

  6. Peel tape back to expose connections.
    • Peel tape back to expose connections.

  7. There are several sets of wires connected to the motherboard as shown in the images.  Carefully disconnect each set of wires. There are several sets of wires connected to the motherboard as shown in the images.  Carefully disconnect each set of wires.
    • There are several sets of wires connected to the motherboard as shown in the images. Carefully disconnect each set of wires.

  8. Use a JIS screw bit #00 to remove screws around the motherboard using the provided image to locate each screw. Use a JIS screw bit #00 to remove screws around the motherboard using the provided image to locate each screw.
    • Use a JIS screw bit #00 to remove screws around the motherboard using the provided image to locate each screw.

  9. Gently pull out motherboard.
    • Gently pull out motherboard.

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Michael

Lid sinds: 03-09-15

513 Reputatie

4 handleidingen geschreven

Team

USF Tampa, Team 8-5, Eyestone Fall 2015 Lid van USF Tampa, Team 8-5, Eyestone Fall 2015

USFT-EYESTONE-F15S8G5

3 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 2

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 17

Altijd: 2,126