Inleiding

There are screws and several cables that need to be removed before the top case will come off. The battery and the keyboard both need to be removed as well.

Onderdelen

Geen onderdelen nodig.

Turn the netbook upside down with the battery at the top, away from you.
  • Turn the netbook upside down with the battery at the top, away from you.

Voeg opmerking toe

Unlock the battery by sliding the switch located near the left hinge to the left "unlocked" position.
  • Unlock the battery by sliding the switch located near the left hinge to the left "unlocked" position.

Voeg opmerking toe

  • Slide the latch located on the opposite hinge from the lock while pushing the battery up.

Voeg opmerking toe

  • Gently loosen the two Phillips #0 screws in the small panel that covers the wireless card.

    • These screws are built into the panel and aren't meant to be completely removed.

Voeg opmerking toe

  • Lift up the panel and remove it from the case.

Voeg opmerking toe

  • Disconnect the two antenna cables from the left side of the wireless card.

Voeg opmerking toe

  • Remove the single 3.9 mm Phillips #1 screw from the bottom left of the wireless card.

Voeg opmerking toe

  • Gently lift up the left side of the wireless card and slide the card out of its socket.

mi lap NO tiene wireless card

gustavo cordova - Antwoord

  • Turn the netbook over and open the display so that the keyboard is facing you.

Voeg opmerking toe

  • There are three tabs located on the top of the keyboard.

  • Start with the spudger pointing towards the display and pry up to push each tab off the keyboard.

  • As you move to the next tab, ensure the previous tab doesn't reset itself.

Voeg opmerking toe

  • Lift top of keyboard up. If it doesn't lift easily, there may be tabs on the sides - use the tool to ease them aside and/or shift the keyboard from side to side.

  • There is a short ribbon cable connecting the keyboard to the netbook.

Voeg opmerking toe

  • Disconnect the ribbon by lifting the black plastic hinge and removing the clear blue cable.

Voeg opmerking toe

  • Close the display and turn the ZG5 over so that the battery compartment faces away from you.

Voeg opmerking toe

  • Remove three 5.8 mm Phillips #0 screws from the bottom of the case

  • Remove three 3.9 mm Phillips #1 screws from the battery compartment.

  • Remove two 5.8 mm Phillips #0 screws from underneath the feet near the hinges.

Voeg opmerking toe

  • Turn the netbook back over and open the display with the keyboard cavity facing you.

Voeg opmerking toe

  • Flip up the retaining flap on the trackpad ribbon cable ZIF connector.

  • Using the blue tab, pull the trackpad ribbon cable from its socket on the motherboard.

Voeg opmerking toe

  • Remove the five black 4.7 mm Phillips #0 screws from the metal casing.

  • Remove the single silver 4.3 mm Phillips #00 screw from the right side of the metal casing.

Voeg opmerking toe

  • Starting at the red rings along the hinge, insert a spudger or plastic opening tool into the seam between the two halves of the case.

  • Slide the spudger toward the front of the device, releasing the small clips that hold down the top case.

  • Gently lift off the top case.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

6 andere personen hebben deze handleiding voltooid.

Doug Gallatin

Lid sinds: 05-10-10

5.778 Reputatie

10 handleidingen geschreven

Team

Cal Poly, Team 7-49, Amido Fall 2010 Lid van Cal Poly, Team 7-49, Amido Fall 2010

CPSU-AMIDO-F10S7G49

5 Leden

10 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 17

Altijd: 14,992