Inleiding

The outer casing protects the internals of the monitor.

Lay the monitor on a flat surface so that the back is facing up.
  • Lay the monitor on a flat surface so that the back is facing up.

Voeg opmerking toe

Grab the hinge cover with both hands on either side of the stand.
  • Grab the hinge cover with both hands on either side of the stand.

  • Squeeze inwards with your thumbs and fingers and lift up to remove the hinge cover.

Voeg opmerking toe

  • Remove the four 12.1 mm Phillips #2 screws that hold the stand to the monitor.

  • Support the monitor while removing the screws to prevent the monitor from falling.

  • Lift up to detach the stand.

Voeg opmerking toe

  • Remove the five 9.5 mm Phillips #2 screws located around the perimeter of the monitor.

Voeg opmerking toe

  • Starting at the corner of the monitor, wedge the small plastic opening tool between the back cover and the display bezel.

  • Tilt the plastic opening tool up to separate the back cover from the display bezel.

  • Continue around the perimeter of the monitor until the display bezel comes off.

  • A reasonable amount of force is necessary to detach the back cover from the display bezel.

Voeg opmerking toe

  • Reposition the monitor so that the back is facing up.

  • Grab the corners of the monitor and jiggle them upwards to detach the back cover from the inside of the monitor.

  • Lift the back cover up.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Keith

Lid sinds: 06-10-11

261 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 20-26, Maness Fall 2011 Lid van Cal Poly, Team 20-26, Maness Fall 2011

CPSU-MANESS-F11S20G26

4 Leden

7 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 5

Altijd: 943