Turn the monitor facedown.
  • Turn the monitor facedown.

  • Unscrew the 5 screws holding the back cover on.

  • (This may require flipping the monitor over and shaking the screws loose once they're already unscrewed)

Voeg opmerking toe

Take the edge tool or a metal ruler and insert it into bezel.
  • Take the edge tool or a metal ruler and insert it into bezel.

  • Apply pressure and push down.

  • Do the same to the right side.

  • Once the side of the bezel facing you is decoupled, take the back cover and pry it loose.

Voeg opmerking toe

  • Remove the Flat Flex Cable from the Power Supply board under the metal cover.

  • Pull the cord back and out of the way.

  • (It may be stuck down with adhesive)

Voeg opmerking toe

  • Unscrew the cord anchors for the VGA port.

  • (Use needle nose pliers if they're too tight for removal by hand)

Voeg opmerking toe

  • Turn the monitor around.

  • Unscrew the 1 screw holding the Flat Power Cable cover in place.

  • Lift up and remove the Flat Power Cable cover.

  • (Careful: it may be sharp)

Voeg opmerking toe

  • Unscrew the 5 screws holding the metal cage on.

Voeg opmerking toe

  • Turn the monitor around.

  • Lift up on the back of the metal cage slightly.

  • Pull the cage toward self.

  • (Must be careful to free the cover of the VGA port and power supply input)

Voeg opmerking toe

  • Lift up on the Flat Flex Cable holder tabs to release the cords.

  • Lift up on the Flat Flex Cables and bend them out of the working area.

Voeg opmerking toe

  • Unplug the 4 backlight wires from their ports on the Power Supply Board.

  • (Considering their size, the best way to unplug the backlight wires is by slowly jiggling and pulling the wires out of place)

Voeg opmerking toe

  • Unscrew the 5 screws holding the joined Power Supply and Video Display boards on.

Voeg opmerking toe

  • Lift and remove the joined Power Supply and Video Display boards.

Voeg opmerking toe

  • Carefully detach the Power Supply and Video Display boards at their connector joint.

  • Replace the Power Supply Board with a new part.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Christopher Kelly

Lid sinds: 25-09-14

586 Reputatie

4 handleidingen geschreven

Team

USF Tampa, Team 1-3, Brown Fall 2014 Lid van USF Tampa, Team 1-3, Brown Fall 2014

USFT-BROWN-F14S1G3

3 Leden

5 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 11

Altijd: 720