Ga door naar hoofdinhoud

2006-2013 Toyota Corolla Ignition Coil Replacement

Wat je nodig hebt

  1. 2006-2013 Toyota Corolla Ignition Coil Replacement, Ignition Coil: stap 1, afbeelding 1 van 3 2006-2013 Toyota Corolla Ignition Coil Replacement, Ignition Coil: stap 1, afbeelding 2 van 3 2006-2013 Toyota Corolla Ignition Coil Replacement, Ignition Coil: stap 1, afbeelding 3 van 3
    • Pop the hood and remove the black plastic cover over the engine.

    • There is nothing to unscrew, or unlatch, and the cover should lift off. Once removed, the top of the engine will look like the third picture

  2. 2006-2013 Toyota Corolla Ignition Coil Replacement: stap 2, afbeelding 1 van 2 2006-2013 Toyota Corolla Ignition Coil Replacement: stap 2, afbeelding 2 van 2
    • Unplug the ignition coil you wish to replace. The coils are numbered one though four, left to right.

    • Do not unscrew the bolt on the ignition coil before this step. It makes the electrical plug more difficult to remove

  3. 2006-2013 Toyota Corolla Ignition Coil Replacement: stap 3, afbeelding 1 van 1
    • Unscrew the bolt of the coil that needs to be replaced.

    • Be sure to put the bolt in a place you will not lose it!

  4. 2006-2013 Toyota Corolla Ignition Coil Replacement: stap 4, afbeelding 1 van 2 2006-2013 Toyota Corolla Ignition Coil Replacement: stap 4, afbeelding 2 van 2
    • Pull the coil straight up and out. It should come off of the spark plug with little resistance.

  5. 2006-2013 Toyota Corolla Ignition Coil Replacement: stap 5, afbeelding 1 van 2 2006-2013 Toyota Corolla Ignition Coil Replacement: stap 5, afbeelding 2 van 2
    • Apply a pea-sized amount of grease to the new ignition coil. It should be all around the rubber tip around the bottom.

    • While not required, this step will make any future replacements much easier.

  6. 2006-2013 Toyota Corolla Ignition Coil Replacement: stap 6, afbeelding 1 van 1
    • When inserting the new ignition coil, press down lightly to ensure it is completely in place.

    • Re-plugging in the ignition coil, and re-screw it in. This can be preformed in either order.

    • Repeat steps three through five as necessary for the other three ignition coils.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Henderson Gillette

Lid sinds: 09/23/23

160 Reputatie

1 Handleiding geschreven

Team

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 8

Afgelopen 7 dagen: 76

Afgelopen 30 dagen: 315

Altijd: 955