Ga door naar hoofdinhoud

Onderdelen

  1. 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Passenger side window regulator (power windows): stap 1, afbeelding 1 van 3 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Passenger side window regulator (power windows): stap 1, afbeelding 2 van 3 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Passenger side window regulator (power windows): stap 1, afbeelding 3 van 3
    • First locate the 4 screws to remove the door panel. See pic1

    • 2 screws are visible.

    • The other 2 screws are behind items.

    • Location of the screws.

    • First screw is under the door lock/window controls. See pic 2.

    • Next screw located lower right of panel behind reflector. See pic 3

    • To remove the door/window controls pry on one end of the controls and lift up. See pic 2.

    • To remove the reflector pry one side and remove from the panel. See pic 3.

  2. 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Removing panel from door.: stap 2, afbeelding 1 van 3 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Removing panel from door.: stap 2, afbeelding 2 van 3 1999-2005 Pontiac Grand Am Passenger side window regulator (power windows) Replacement, Removing panel from door.: stap 2, afbeelding 3 van 3
    • Before removing panel, remove small tweeter speaker from top of door panel.. Clipped in just pull the top. Pic 1

    • After removing screws, Pull on the panel around the outside to release the pop-in clips.

    • Then remove the panel from the door by lifting up and backward on the panel. Pic 2

    • Be mindful of the rail on top of the panel that may or may not fall off the panel.

    • Also make sure you remove any wires that is connected to the door panel. Lock controls, tweeter speaker wires.

    • On the bottom of the glass inside the door there are two bolts that hold the window to the plastic track on the regulator.

    • Before you remove the second screw hold the window to prevent breakage of the window.

    • While holding the window remove the second screw and lift out the window from the door.

    • Locate and loosen the 4 bolts holding the regulator. See pic 1.

    • Then remove the window regulator motor and all of the track from the door...

    • Then replace the regulator and reverse the procedure to install the regulator back in the door.

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

shawn streitmatter

Lid sinds: 25-11-13

251 Reputatie

1 Handleiding geschreven

0 Opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 9

Afgelopen 30 dagen: 67

Altijd: 8,112