Ga door naar hoofdinhoud

Inleiding

When a car is driven, tires tend to wear unevenly. To extend the life of tires, it is important to rotate the tires every 30,000 miles. This guide will show you how to remove and rotate tires.

Gereedschap

Onderdelen

Geen onderdelen opgegeven.

  1. Turn car off and remove keys from ignition.
    • Turn car off and remove keys from ignition.

    • Place car in park (automatic) or neutral (manual).

    • Engage parking brake.

  2. Use hydraulic jack on frame of car to raise car.
    • Use hydraulic jack on frame of car to raise car.

    • Place jack head underneath frame of car.

    • Only necessary to jack the car until the wheels are just off the ground.

  3. Place jack stand on frame of car and remove jack.
    • Place jack stand on frame of car and remove jack.

    • Do no work under car supported only by hydraulic jack, serious injury or death may occur.

  4. Turn car off and remove keys from ignition.
    • Turn car off and remove keys from ignition.

    • Place car in park (automatic) or neutral (manual).

    • Engage parking brake.

  5. MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now

    MacBook-reparatiesets voor batterijen

    Vanaf $69.99

    Buy Now
  6. Use hydraulic jack on frame of car to raise car. Place jack head underneath frame couple (pictured).
    • Use hydraulic jack on frame of car to raise car.

    • Place jack head underneath frame couple (pictured).

    • Only necessary to jack the car until the wheels are just off the ground.

  7. Place jack stand on frame of car and remove jack. Do not work under car supported only by hydraulic jack, serious injury or death may result.
    • Place jack stand on frame of car and remove jack.

    • Do not work under car supported only by hydraulic jack, serious injury or death may result.

  8. Pry off the all four hub caps by placing a small flathead screwdriver between hubcap and rim pulling the screwdriver away from tire. Pull hubcaps away from tires.
    • Pry off the all four hub caps by placing a small flathead screwdriver between hubcap and rim pulling the screwdriver away from tire.

    • Pull hubcaps away from tires.

  9. Loosen each of the five lug nuts on all tires by turning them counter-clockwise with a 19mm wrench.
    • Loosen each of the five lug nuts on all tires by turning them counter-clockwise with a 19mm wrench.

  10. Remove tires by pulling directly away from car exposing brake rotors.
    • Remove tires by pulling directly away from car exposing brake rotors.

  11. Swap tires according to diagram.
    • Swap tires according to diagram.

  12. Place tires on axels.
    • Place tires on axels.

    • Hand tighten the lug nuts with narrow end of nut towards car.

    • Finish tightening the lug nuts with 19mm Torque Wrench to a torque of 63 lb*ft.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Garrett Van Ruiten

Lid sinds: 11-10-10

51 Reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 3-28, Regan Fall 2010 Lid van Cal Poly, Team 3-28, Regan Fall 2010

CPSU-REGAN-F10S3G28

4 Leden

9 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 1

Altijd: 2,344