Firstly Disconnect  battery
  • Firstly Disconnect battery

    • Always take the negative terminal off first.

    • '''General Tip After disconnecting the battery leave the car for about 10 mins , This lets any residual energy left in the electrical system to dissapate. It is good practise whatever the job

Voeg opmerking toe

Unlatch the 2 clasps.
  • Unlatch the 2 clasps.

  • Loosen screw on metal band.

Voeg opmerking toe

  • Disconnect electronic sensor.

  • Press on the 2 latches, pulling the cable away from sensor.

Voeg opmerking toe

  • Disconnect hose from MAFS.

  • Remove MAFS.

Voeg opmerking toe

  • Steps 4-6 are for cleaning only.

  • Spray MAFS cleaner along direction of travel, shown by arrow.

Voeg opmerking toe

  • Clean electronic coupling with electronics cleaner.

Voeg opmerking toe

  • Inject conducting lubricant into MAFS electronic coupling.

Voeg opmerking toe

  • Re attach MAFS to air filter housing and intake hose.

  • Tighten screw on metal band.

  • Latch clasps on either side of MAFS.

Voeg opmerking toe

  • Re attach electronic cable to MAFS.

Voeg opmerking toe


To reassemble your device, follow these instructions in reverse order.

Isaac Nitschke

Lid sinds: 11-10-10

61 Reputatie

5 handleidingen geschreven


Cal Poly, Team 3-28, Regan Fall 2010 Lid van Cal Poly, Team 3-28, Regan Fall 2010


4 Leden

9 handleidingen geschreven

Voeg opmerking toe


Afgelopen 24 Uren: 1

Afgelopen 7 Dagen: 6

Afgelopen 30 Dagen: 18

Altijd: 7,961