Ga door naar hoofdinhoud

Vind antwoorden in dit document

We hebben alle pagina’s op 8 al doorgenomen, zodat jij dat niet hoeft te doen. Stel je vraag en krijg meteen antwoord.

DSC W220 Disassembly

8 pagina's · 2.13 MB · PDF

2-2. DISASSEMBLY

2-2-1. LCD SECTION

Follow the disassembly in the numerical order given. 1 Cabinet (Rear) ( 1 -1 to 1 -3) 2 LCD ( 2 -1 to 2 -12)

EXPLODED VIEW

HARDWARE LIST

2-2-2. FRONT SECTION

Follow the disassembly in the numerical order given.

  • 1 Lens Block ( 1 -1 to 1 -9)
  • 2 BT Holder Section ( 2 -1 to 2 -2)

EXPLODED VIEW

HARDWARE LIST

2-2-3. BT HOLDER SECTION

Follow the disassembly in the numerical order given.

1 Cabinet (Upper) Block ( 1 -1 to 1 -5) 2 SY-214 Board ( 2 -1 to 2 -4)

EXPLODED VIEW

HARDWARE LIST

2-3. PRECAUTIONS WHEN HOLDING THE LENS BLOCK

  • Hold the Lens Block at the center of both sides.
  • Do not hold the following part.

2-4. BARRIER ASSY REPLACING METHOD

Removal

  • 1 Turn on the power switch and extend the lens.
  • 2 Detach the battery.
  • 3 Pour a solvent such as alcohol from two places A to the tweezers or a needle shown below into a gap of Ornamental Ring A.
  • 4 Remove while turning the Ornamental Ring A right and left.

Installation

  • 1 Affix two Barrier Tapes to Barrier Assy. Note: The tape must not be wrinkled.
  • 2 With four claws fitted in position, install the Barrier Assy.

2-5. LENS MOTOR REPLACING METHOD

Replace the parts if the following events appear when the power switch is turned on.

  • 1 "Turn off and on the power" is displayed without performing the zoom operation.

Replace Zoom Gear Block if a damage of lens barrel due to a drop of camera is not found.

(See "2-5-1. Zoom Gear Block Replacing Method")

Replace Lens Block if such replacement does not improve the failure.

  • 2 "Turn off and on the power" is displayed after the "lens zooming in and out" operation over its full stroke was repeated 3 times.

Replace Optical Stepping Motor. (See "2-5-2. Optical Stepping Motor Replacing Method")

Replace Lens Block if such replacement does not improve the failure.

2-5-1. Zoom Gear Block Replacing Method

Removal

  • 1 Remove one screw.
  • 2 Remove Zoom Gear

Meld je gratis aan bij iFixit om het volledige document te lezen (8 pagina's)

We vragen je om een gratis account aan te maken, zodat we bots buiten de deur kunnen houden en iFixit voor mensen blijft.

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 14

Afgelopen 30 dagen: 21

Altijd: 181