Ga door naar hoofdinhoud

Vind antwoorden in dit document

We hebben alle pagina’s op 18 al doorgenomen, zodat jij dat niet hoeft te doen. Stel je vraag en krijg meteen antwoord.

TX1080Z Service Manual

18 pagina's · 3.82 MB · PDF

FMIAM DIGITAL SYNTHESIZER TUNER

MODEL TX-1080Z COMES IN TWO VERSIONS DISTINGUISHED AS FOLLOWS:

TypePower requirementDestination
Z/UC(DC power supply)U.SA. and Canada
{DC power supply)General market

Table Caption: This table outlines the power requirements and destination markets for a "Z/UC" type product. It indicates that a DC power supply is required for use in the U.S.A. and Canada, as well as for the general market.

  • This service manual is applicable to the ZIUC and Z types.
  • Ce manuel dinstruction se refère au mode de réglage en français. (p: 24
  • As to the Z type, please refer to page 28.
  • Este manual de servicio trata del método ajuste escrito en español. (p. 26 p. 27).

CONTENTS

1SPECIFICATIONS 2
2 PANEL FACILITIES _3
3 PACKING5
4. EXPLODED VIEWS AND PARTS LIST6
5. SCHEMATIC DIAGRAM.9
6. PC. BOARDS CONNECTION DIAGRAM13

Table Caption: This table outlines the specifications for a product, detailing sections such as panel facilities, packing, exploded views with parts lists, schematic diagrams, and PC board connection diagrams. It serves as a table of contents or index for the technical documentation.

ELECTRICAL PARTS LIST.

7 .

  1. RÉGLAGE

ADJUSTMENTS

9

AJUSTE

FOR Z TYPE

20

22

24

26

28

1. SPECIFICATIONS

FM Tuner Section

Frequency range

Usable Sensitivity (IHF)

5OdB Quieting Sensitivity

87.5 MHz to 108 MHz

12.7dBf (1.2pV/7502)

MONO: 18dBf (2.2pV/7502)

Signal-to-Noise Ratio

STEREO: 38.3dBf (22.6uV/7502)

Mono; 77 dB (at 85 dBf)

Distortion

Stereo; 73dB (at 85 dBf)

Alternate Channel Selectivity

Stereo Separation

Frequency Response

Image Response Ratio

Antenna Input

IF Response Ratio

Output

0.5% (1 kHz

60 dB (400 kHz)

40 dB (1 kHz)

30 Hz to 15 kHz (+1 dB)

38 dB

110 dB

300 $2 balanced

75 ( unbalanced

650mV (100% MOD.)

AM Tuner Section

Frequency range (1OkHz/9kHz step) 530/531 kHz to 1,700/1,602 kHz
Sensitivity (IHF, Loop antenna) 350 jV/m
Selectivity 20 dB
Signal-to-Noise Ratio 45 dB
IF Response Ratio 50 dB
Antenna Loop Antenna Output 150 mV (30% MOD.)
Miscellaneous
Dimensions 420 (W) x 60 (H) x 215 (D) mm 16-1/2 (W) x 2-3/8 (H) x 8-7/16 (D) in
Weight (without package) 2 kg (4 Ib 6 oz)
Furnished Parts
FM T-type Antenna AM Loop Antenna

Table Caption: This table provides the technical specifications and physical dimensions for a device, likely a radio receiver, focusing on its AM band capabilities including frequency range, sensitivity, selectivity, signal-to-noise ratio, and antenna output, along with its size, weight, and included accessories.

2. PANEL FACILITIES

FM MONO switch /indicator

is set to the off position (the FM MONO indicator goes off) . When noise spoils the reception of an FM program, press the switch to the on position (the FM MONO indicator will now light)

The program of an FM stereo broadcast will be heard in mono. The setting of the FM MONO switch (on or off) is memorized along with the station's frequency in the STATION CALL switches.

When using the preset tuning feature, reception will be in the mode selected when the station was memorized.

This switch will not function for AM reception.

AUTO/MANUAL tuning switchlindicator

Use to select either the AUTO mode or MANUAL mode for FMIAM reception. (When the auto tuning made is selected , the AUTO TUNING indicator will now light.

STATION CALL switches

These are used to recall preset broadcasting stations and to preset the station

MEMORY switch

This switch is used to memorize stations. When the switch is pressed , the ency indicator will flash. To memorize the frequency of any station, press the STATION CALL switch while the frequency display is flashing. freque

FREQUENCY display

Permits reading the received frequency at a glance from the displayed figure. The FM band is indicated by MHz, and the AM band by kHz

TUNING switch

This is used to locate the stations Push either side of this switch; the left side to go to a lower , the right side to g0 to a higher frequency. and

STEREO indicator

This lights when stereo program has been picked up during an FM broadcast.

TUNED indicator

This lights to indicate when the finest tuning of a station has been achieved

BAND SELECTOR switch

This is used to select the band of the desired station. The bands change alternately each time the switch is pressed.

Radio reception is not possible unless the antenna is properly connected

The strength of broadcast signals varies from one area to another (signal propagation is especially poor in metropol itan areas where there are in mountainous areas) . Proper antenna installation is vital to good reception.

AM ANTENNA

The AM antenna supplied with the tuner should be connected to the AM antenna terminals. The antenna should be placed at a distance from the tuner, and should not be allowed to touch metallic objects Avoid placing it and other devices generating radio frequencies: loop

Setting Up the AM Antenna

  • Place the antenna on a level surface and rotate it to locate the orientation that yields best reception_ the
  • Fold out the supports on the bottom of the antenna Insert the stopper in the hole in the antenna to lock them in place.

AM Loop Antenna Set-up

accessory AM loop antenna must be connected to ensure_proper_reception_ The

External AM antenna

Indoor AM antenna

Provide a vinyl-coated wire (5 to 6 meters long) . Secure one end to the AM terminal and the other end to a wall or other high location.

Outdoor AM antenna

stretched out indoors, stretch out a vinyl-coated wire and secure it outdoors_

Connecting the external AM antenna

NOTE:

Do not detach the AM loop antenna when using the external AM antenna_

FM ANTENNA

FM T-type Antenna Attachment

Connect the accessory FM T-type antenna to the FM terminals. Stretch the antenna out to its full length, and affix it to a wall, etc.

Stretch out both ends

External FM antenna installation

Use an external antenna when the signals the station are weak and cannot be picked up by the accessory T-type FM antenna, or when the sound heard is accompanied by large amounts of noise There are two ways of

Meld je gratis aan bij iFixit om het volledige document te lezen (18 pagina's)

We vragen je om een gratis account aan te maken, zodat we bots buiten de deur kunnen houden en iFixit voor mensen blijft.

Weergavestatistieken:

Afgelopen 24 uren: 12

Afgelopen 7 dagen: 12

Afgelopen 30 dagen: 14

Altijd: 85