Repareer je spullen Gemeenschap Winkel

Reparatie- en probleemoplossingsinformatie voor het FixHub Mobiele Soldeerstation, de primaire stroombron en controle-interface voor iFixit's FixHub-productlijn. Wordt gelanceerd in oktober 2024.

20 Vragen Bekijk alle | 17 Onderdelen Shop

Opties

Has anyone had an issue with the battery erroring out?

Hello everyone,

I purchased the FixHub and it works wonderfully except for one small issue. When powering the iron off, after a while I will receive a battery charging halt error at 98%.

otherwise the iron works fine and discharges and charges as normal. Is this just a visual error, or is there something I should look into? I am on firmware 1.0.5

Thanks!

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 4
9 opmerkingen

I’ve forward your issue to the iFixit product team for a response.

door

@danj, thank you.

@kaioshade, we're looking into it.

door

@krisrodriguez Thank you so much for the swift reply.

For some additional information, I am using an Anker Nano II 65W USB-C charger, with an Apple USB-C 240W cable. I have not tried any other chargers yet.

door

@kaioshade, you're welcome!

Thanks for the extra information. I have a follow-up question. Have you calibrated the battery? It's a button in the web UI. It's somewhat expected to have some variance up front with max charging percentages until this is done.

door

@krisrodriguez

I did not do the calibration when I got the unit (apologies, I didn't think to), but I did it tonight. I'll report back if it does happen again. Thanks for the info!

door

4 commentaren meer tonen

Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Het nuttigste antwoord

Opties

Mine has only been used a handful of times, and the battery has been self discharging over a week by more than 10%

I also saw that the health percent for it is already down to 89%

Was dit antwoord nuttig?

Ja Nee
Score 1

3 opmerkingen:

@omegatotal, have you tried updating to the latest firmware?

door

I just did through every version, now the battery health is MIA, and replaced with a setting for setting the max battery charge.

Also it appears that it is not respecting the inactivity/timeout that I had previously set to 30 minutes (its stayed on for multiple hours today after a couple of power cycles)

door

I just tried changing it to 29 minutes and back to 30 minutes after it stayed on without being touched for 2 hours. lets see what it does this time.

door

Voeg een opmerking toe

Voeg je antwoord toe

Cien zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 2

Afgelopen 7 dagen: 10

Afgelopen 30 dagen: 25

Altijd: 405