Ga door naar hoofdinhoud

Model No. A1367 / 8, 16, 32, or 64 GB capacity

913 Vragen Bekijk alle

Black screen after replacing flex cable. [SOLVED]

[THE PROBLEM]

I ran into an issue in the shop where after replacing the Flex cable every screen I tried was black. The iPod wouldn't even beep when plugged in.

Since I googled the tar for a solution, and couldn,' find one, I'll post what I found for anyone else with the same problem who hasn't been able to find a solution.

The solution is moved below, to the answer so that it can be cleared per request.

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Score 2
2 opmerkingen

Please use the last paragraph as an answer and accept it to clear the question.

door

Thanks for letting me know guys, I did as you suggested.

door

Voeg een opmerking toe

1 Antwoord

Gekozen oplossing

[HOW TO FIX IT]

I covered the circuits around the flex cable and de-solder it then cleaned up the pads and soldered on the new flex.

Not adhering to my own soldering instructions, of course I got in a rush and did this without de-soldering the + terminal on the battery first.

In my case, I went back and disconnected the + terminal on the battery and soldered it back on. The black screen went away and the iPod kicks up just fine.

I hope this helps fellow techs that may have found this.

Was dit antwoord nuttig?

Score 3
Voeg een opmerking toe

Voeg je antwoord toe

Country Computer Service zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 2

Altijd: 3,293