Repareer je spullen Gemeenschap Winkel

The Apple Watch Series 1 is a revamp of the original Apple Watch, announced September 7, 2016. Most of the parts are the same as the Series 2

123 Vragen Bekijk alle

Opties

Replacing Apple Watch Screen & Force Touch Sensor

Hi - I’ve tried once, and the screen would not adhere permanently. Does anyone have advice on the best steps to ensure the screen stays adhered? I cleaned all surfaces well with alcohol before and it still did not stay adhered. I see there are two adhesive gaskets included with the kit. Should I try to use one - first before the force touch sensor, on the Watch body, then the FT sensor, then another adhesive on top of that? Not sure if this will add too much thickness.

Any other suggestions are welcomed. I have another Ft sensor arriving today in the mail and want to get it right this time.

Thanks

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Het nuttigste antwoord

Opties

https://youtu.be/s5-5pGfRgVc

Was dit antwoord nuttig?

Ja Nee
Score 1

2 opmerkingen:

Thanks for the response but this doesn’t answer the question I asked. I’ve watched all the ifixit videos already and followed the proper steps. The screen won’t adhere. And, I’m not the only one experiencing this.

My question was why they included TWO extra gaskets, and it it’s possible / recommended to use one first before the FT sensor and then another after the sensor - to help ensure the screen doesn’t pop off again.

door

There are two adhesives, they go either side of the force touch gasket. One sticks the gasket to the watch and one sticks the screen to the gasket. Don’t worry about thicknesses.

door

Voeg een opmerking toe

Voeg je antwoord toe

Chris zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 4

Altijd: 62