Rep: 454
5
2
1
I opened up my computer so I can clean out the dust and everything.But when I was connecting everything I accidentally
ripped out the grey wire that connects to the airport card.What Can I do and Can I replace it.
Is dit een goede vraag?
Rep: 478,9k
35
329
970
Ouch! These Coax connectors are a bit tricky to replace, they can be found.
The other option which is how I deal with it, is to replace the full cable! Here’s a source IPEX U.fl MHF 4 Plug RG-0.81 RF Pigtail Coaxial Jumper Cable OD 0.81mm Black Connector 10cm 15cm 20cm 30cm But you need to get to the other end and soldering in the new one.
The other direction is quite drastic but might in the end be easer and cheaper for you. Thats getting a replacement housing! iMac Alu 20" Rear Housing Unit/w Chassis - $17 USD! Then you just need to move things over.
Was dit antwoord nuttig?
Thank You So much @danj I think I will go for the second Option.
Rep: 685,2k
3,4k
1,1k
2,6k
From your photo it look nearly disconnected. Just snap it back onto the connector on the wi-fi card.
iMac Intel 20" EMC 2133 and 2210 AirPort Extreme Replacement
Was dit antwoord nuttig?
The golden connecter ripped and I can't connect it.
Afgelopen 24 uren: 0
Afgelopen 7 dagen: 0
Afgelopen 30 dagen: 0
Altijd: 36
2 opmerkingen
@jellybean4_30 did the connector rip on the board or on the cable?
door oldturkey03
@oldturkey03 The connector on the cable.
door Keshawn Vasugan