Repareer je spullen Gemeenschap Winkel

Repair information and guides for the iPhone 6 Plus that was released on September 19, 2014. Model: A1522, A1524

1525 Vragen Bekijk alle

Opties

touch disease,, -5.7v problem

hi

i have iphone 6 plus with touch problem first i make jumper M1 pin on u2402 because this pin missing then test with diode value and resistant is normal but touch still disease and i measurement PN5V7_SAGE_AVDDN and this voltage only 5.3v im allready change chestnut (u1501) but the problem same -5v7 still low voltage

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

Have you tried a known good screen?  What is the phones history?

You should not have touched chestnut. Now you have added variables to your repair. I have measured different voltages on that line and yours is acceptable.

You need to diode the connector and find what line is missing. If all the pins measure right I would try another meson than cumulus.

Was dit antwoord nuttig?

Ja Nee
Score 1

1 Opmerking:

phone was dropped from a few feet before

i was change lcd and problem still same

and diode value on connector was normal,, and change cumulus and meson (i get from normal board iphone) problem still same

door

Voeg een opmerking toe

Voeg je antwoord toe

Ronald E zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 73