Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Released September 21, 2018. Models A1920, A2097, A2098, A2100. Available as GSM or CDMA / eSIM or nano-SIM / 64, 256, or 512 GB / Silver, Gold, or Space Gray. (Pronounced "iPhone 10 S.")

154 Vragen Bekijk alle

iPhone XS laging and restarting after 3mn

Hello,

I did a back glass replacement and after reassembling the phone. It is laging. I tried to do some troubleshooting

1- when i disconnect the back and front camera the phone works well with no lag

2- when i connect only the back camera the phone lags ( the camera is work but not a the first attempt )

3- when i connect only the front camera the phone lags ( and face id says “face not visible” )

4- when i connected both cameras, phone lags ( both cameras are working, but the flash doesnt )

5- For the restarting issue i think i damaged the charging port while removing the back glass. I read that in another forum

Please help. I dont know what else to do

Beantwoord! View the answer Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

2 Antwoorden

Gekozen oplossing

Back Glass or Whole Housing replacements can suffer from the same issues, mainly damaged flexes or connectors. If the phone works fine without the cameras, then closely examine the camera flexes and connectors (and the equivalent connectors on the logic board.

Look for tears in the flexes, even the tiniest ones. Sometimes the connector pins get damaged or some surrounding components can be fully or partially dislodged. All of this inspection may require some magnification.

EDIT 2020-10-26

Take a closer at this flex, based on your picture below (https://ibb.co/g9qRMTj).

Block Image

Was dit antwoord nuttig?

Score 2

Commentaar:

I doublechecked the connectors and the flexs but i haven´t seen any damages. These are some macroshoots i took, maybe there can be helpful.

What about the restart after 3minutes ? Is It the Charging port which needs to be replaced ?

https://ibb.co/G2yvSwF

https://ibb.co/7kYG0Q4

https://ibb.co/D8gF0FP

https://ibb.co/F3nXKRQ

https://ibb.co/QJcmmXK

https://ibb.co/VWcXHDD

https://ibb.co/pR8S4CS

https://ibb.co/g9qRMTj

https://ibb.co/cCbscS9

https://ibb.co/GPqB8m9

https://ibb.co/wzyrhQ7

https://ibb.co/Kh1Bntb

https://ibb.co/H4vmPSY

https://ibb.co/9HXD2gs

door

I double checked the flex but it is not damaged. i took a better picture

https://ibb.co/N1WHX5W

door

Voeg een opmerking toe

Hello Michel,

While the phone is on connect it to your pc run CoconutBattery app: https://www.coconut-flavour.com/coconutb...

If the design capacity shows value around 100mAh (normal value would be the thousands range ~2000-2658mAh)it would suggest you damaged either the battery connector or a tiny component around the connector. If that’s the case you would need a professional to fix it. It would help if you cold post pictures of the battery connector in question.

Was dit antwoord nuttig?

Score 0

Commentaar:

Heloo Roman,

thank for your response. I don´t have a Mac but a Windows PC. I used 3UTools to check the Ah. It shows 2642mAh as designed capacity.

These are some pictures.

https://ibb.co/yVmM1Nf

https://ibb.co/m0x4VDt

https://ibb.co/TYgWYBq

https://ibb.co/yYcyFq2

door

Voeg een opmerking toe

Voeg je antwoord toe

Michel Ngne zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 29

Altijd: 41