Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Model A1136 / 30, 60, or 80 GB hard drive / black or white plastic front

907 Vragen Bekijk alle

Why doesn't work the backlight of my iPod?

Hi everyone!

This is a big problem for me because I love this iPod. The ,,back” button (left button) under the clickwheel was broken. I have a donor motherboard so I just replaced the broken button. I tested the iPod after the button replacement work and everything was fine then I put the motherboard in my ultrasonic cleaner because I used flux. After the ultrasonic cleaning the backlight didn’t work. I tried with an another display but the situation is same.

I need a schematic to the repair or any advice that where can I find the backlight circuit.

Please don’t write that: ,,Just buy an another motherboard”. This isn’t worth It and I just want to repair this iPod.

Thanks in advance to the replies.

Beantwoord! View the answer Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

OPEN ALLE TABBLADEN

RAM-upgradekits voor Mac

Koop kits

Genoeg RAM
voor al je tabbladen

Koop kits

1 Antwoord

Gekozen oplossing

@karl67 schematics for the iPod are not available. Since you have a donor board you would have to go and measure the components and see if you find the one that has shorted out. I would focus on the coil around the display connector. If you have a meter you can check pin 30 which should be Backlight -Neg and pin 31 +Pos there will be a boost circuit to get the backlight voltage (again check for shortened out coil)

Was dit antwoord nuttig?

Score 0

Commentaar:

Thank you for the answer! I will check the pin 30.

door

Voeg een opmerking toe

Voeg je antwoord toe

Norbert Jauch zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 4

Afgelopen 30 dagen: 19

Altijd: 19