Ga door naar hoofdinhoud

burnt my balls off

Hello engineers I’m a newbie with a simple question for you. I am trying to learn how to micro-solder and was practicing on an i-phone 7 logic board, attempting to remove the audio i.c. Probably too complicated for training, but after i finally got the i.c. off I noticed several of the balls on what I guess would be the base were missing. They looked silver as opposed to the copper colored ones on the i.c. I tried to apply solder thinking the solder would be attracted to the spot where it should go but no luck

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

2 Antwoorden

Gekozen oplossing

The iPhone 7 audio IC has a few NC pads that usually come off with the chip. These are not required and are not connected to any circuit that is why they come off. Check the ones that came off are not NC pads.

Block Image

Blue pads are NC

Was dit antwoord nuttig?

Score 1

1 Opmerking:

Great info, thanks again

door

Voeg een opmerking toe

that is called ripped pads on the motherboard, and its bad, if you have schematics, you can check what the damaged pads are for. maybe you can bridge them. you have to practice more, since this happens when you don’t use the correct amount of air/heat/flux. this all depends on the calibration and brand of your hot air station. keep practicing

Was dit antwoord nuttig?

Score 0

2 opmerkingen:

Thanks so much and after doing lots of research and thinking about it I discovered one mistake that hasnt been helping me. I bought a cheaper chinese hot air station, Zeny 832D which is ok for me now, but I have been setting the temps for farenheit but my station is set for celcius so my temps havent been correct

door

Awesome, I didnt know that, how would I know the difference tho?

door

Voeg een opmerking toe

Voeg je antwoord toe

mikespring1972 zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 57