iPhone 6 Plus tristar donor board pulled pad.
I am new to microsoldering, I was wicking the board to clean it off, and I ended up pulling two pads at the bottom left of the board. Had the microsoldering at 380 is this to hot to wick the board? By the way this is a donor board.
the two on the first column were pulled. Can I still put the tristar chip on or is it dead.
Is dit een goede vraag?
1 Opmerking
Just a thought here. You might want to add a couple of photo's to your query so participants can get a better feel for what kind of situation you are experiencing.
Voeg afbeeldingen toe aan een bestaande vraag
https://old.reddit.com/r/mobilerepair/ is also another source of information you may want to access
door prop man