Repareer je spullen Gemeenschap Winkel

Apple's 6th revision to the iPod Touch lineup, released in July 2015.

149 Vragen Bekijk alle

Opties

New Battery, apple logo blinks on and off, but doesn't boot.

So, I followed the incomplete guide to solder in a new battery, and it worked!

But now when I try to turn it on (before I fully close it up and get everything going again) it starts with the apple logo, stays there for maybe half a second, goes black, and repeats the process until I press the power button to turn it off again.

What do I do?


Additional info: I used flux.

(as a note, but not relevant to the question, I did poke my screen a bit, so it’s “damaged”, but functional. It’s like a wrinkle under the glass, on the side.)

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

Are you certain the connections on the flex and connection were in line when you soldered them? If so, it’s going to be either a bad battery or further component damage. The easiest way to diagnose this issue is to try again with a known good battery.

Was dit antwoord nuttig?

Ja Nee
Score 1

1 Opmerking:

It was componant damage. I burnt a copper pad.

So, I screwed up, but you had the right answer. Thank you for trying!

It was my first solder job, so it's to be expected I'd make mistakes. I didn't think I'd make one that BIG, though.

door

Voeg een opmerking toe

Voeg je antwoord toe

No_ zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 4

Afgelopen 30 dagen: 5

Altijd: 32