Accessories not gripped tightly
After tightening an accessory into place with the collett nut, it doesn’t grip enough, so tool such a saw just stops when pressed against object.
Is dit een goede vraag?
Score
0
582177
1 Antwoord
Het nuttigste antwoord
Rep: 8,2k
24
12
8
Measure the shaft on the tool in question. It is probably 3/32” and you probably have a 1/8” collet installed in the collet nut. If you have lost that part or did not get it with the tool they are readily available on line.
Was dit antwoord nuttig?
Score
2
