Ga door naar hoofdinhoud

iPhone 7 Stuck On Apple LOGO

Hi Guys.. Hi @refectio SIR

I have an iphone 7 (NOT water Damage). When i connect it to DCPS, show 0,22 0,23 amp, and stuck on these values. 

There is only apple logo on the screen.

Dont restart, just stuck on apple logo.

Check Audio IC, but no improve.

The phone doesn't HOT, there is no short on the board.

I found only long screw damage near the battery, unfortuanlly i did'nt find nothing on ZXW about LSD on phone 7.

If i try to reset have error 9.

Block Image

Is there any suggestion  plz?

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Score 0
Voeg een opmerking toe

3 Antwoorden

Het nuttigste antwoord

Try replacing tristar as it can cause stuck on apple logo. I’ve had one point where it would have no display but show 0.17A on the DCPS, then pointed to a shorted tristar (it heated up a pad under the PMIC):

https://www.youtube.com/watch?v=mcUgeDTt... at start if video pretty much same short I had.

Was dit antwoord nuttig?

Score 2
Voeg een opmerking toe

My answer is replacing the battery. If you watch Hugh Jeffreys, you will know that he had the same problem with one of the iPhone 7 he was refurbishing. Your problem here is that your battery is dead and unable to charge. [Link removed]

After receiving the battery, find the right guide on ifixit.com and your iPhone will work!

Was dit antwoord nuttig?

Score 1

2 opmerkingen:

So it might be a battery replacement problem ???

door

I do a lot of fornite gaming on it. You think it might went bad i used it while charging all the time is that bad?

door

Voeg een opmerking toe

Thanks Everyone Guys.. its a Nand problem. I reball the Nand and phone turn on and work perfectly.. Thanks

Was dit antwoord nuttig?

Score 0
Voeg een opmerking toe

Voeg je antwoord toe

AGS zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 6

Afgelopen 30 dagen: 26

Altijd: 1,959