Repareer je spullen Gemeenschap Winkel

Repair guides and support for top and front loading Whirlpool brand washers.

426 Vragen Bekijk alle

Opties

Whirlppol Washer not spinning

Whirlpool top loader washer model number WTW4800BQ1 will not spin or agitate. After it fills with water the motor will kick on and it it will agitate for like one second and stop. After sitting for a minute it will do the same thing again and then stops. It never proceeds to wash and eventually will drain. I have already replaced the lid switch thinking that was the issue. I went through the diagnostic test mode and it showed F7-E5 and F7-E6 errors. These coordinate to a shifter fault and a motor fault. Since the motor turns I’m guessing shifter issue. Thoughts…

Beantwoord deze vraag Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 2
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Het nuttigste antwoord

Opties

Cause 1

Motor Coupling

The motor coupling connects the motor to the washer transmission. If the washer is overloaded, the motor coupling will fail in order to protect both the motor and transmission. The motor coupling can also fail due to normal wear. Inspect the motor coupling to determine if it is broken. If the motor coupling is broken, replace it.

Cause 2

Drive Belt

Inspect the drive belt to determine if it is broken or if it is loose on the pulleys. If the drive belt is broken or loose, replace it.

Was dit antwoord nuttig?

Ja Nee
Score 2

2 opmerkingen:

Coupling was fine.

Drive belt was also fine.

Still thinking it was the shift actuator

Will know for sure tomorrow after I put in a new one in.

door

Replaced the shift actuator (took all of 5 minutes) and the washer is up and running.

door

Voeg een opmerking toe

Voeg je antwoord toe

Gary Mckee zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 7

Altijd: 769