Repareer je spullen Gemeenschap Winkel

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Vragen Bekijk alle

Opties

How to fix a bent pad and a ripped one?

Hi.

I was trying to fix an iPhone 6 with a broken LCD fpc connector.

When I removed it I noticed that there are a bent pad a ripped one(not completely, a tiny part is remaining).

How can I fix it?

Thanks.

Beantwoord! Bekijk het antwoord Dit probleem heb ik ook

Is dit een goede vraag?

Ja Nee
Score 0
Voeg een opmerking toe

1 Antwoord

Filteren op:
Meest nuttige Nieuwste Oudste
Gekozen oplossing

Opties

A picture might help evaluation but in general there's not much to do besides hoping it's an unconnected or ground pin or just rebuild it with solder and a very thin wire. Some good quality solder wick has plenty of suitable thin copper wires for the job :)

Was dit antwoord nuttig?

Ja Nee
Score 5

4 opmerkingen:

If you want to do micro-BGA pad work on an iphone, then 0.02mm (50AWG) jumper wire is the way to go. For more general work, like long jumpers, then 42AWG enamelled wire is good.

door

Thank you for the trick with the solder wick I didn't know it :)

What tipe of tip(dimension and tipe) is required for this job?

door

I'm sure somebody might object about the solder wick wire but it does the job nicely as far as I could experience. If I have room enough as in this case I use a 0.4mm round shaped tip but it's just a personal preference..anything you're comfortable with and helps you do the job nicely will do. Happy soldering :)

door

Ok,thank you

door

Voeg een opmerking toe

Voeg je antwoord toe

Lorenzo zal eeuwig dankbaar zijn.
Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 83